Mounting
4.16 Mount the toothed belt
1. Place the toothed belt around the operator pulley on the DRIVE UNIT and the
guide pulley on the tensioning device. If there is a locking device, guide the
toothed belt through the open locking device.
1.
Fig. 49
2. Insert both ends of the toothed belt into the upper toothed belt engaging unit
in such a way th a t both ends reach the center of the toothed belt engaging
unit.
2.
Fig. 50
3. Put the cap on.
Fig. 51
3.
ES 250 PRO Easy
2024-03
34
ES250ProEasy Installation Manual
To Next Page