Dormakaba LA GARD 705 - Time Delay Count Mode - Display Keypad; Enable;Disable Time Delay - Non-Display Keypad

dormakaba USA Inc. System User Guide 7040.0321 | 29
4. To change the TimeDelay period, do the following:
a) Select ConfigureTimes
b) Select Delay Period
c) Use the keypad to input a new Time Delay (between 00 [Disabled] and 99 minutes)
Note: For a multi-lock setup, repeat Steps 1 through 4 for each safe lock.
d) Success TD Updated appears on screen and the Keypad will beep three times and flash a green LED
once complete
5. To change the Confirm Window time (the time frame in which the safe lock can be opened), do the following:
a) Select TimeDelay
i. For multi-lock systems, select the corresponding lock number on the keypad
b) Select ConfigureTimes
c) Select ConfirmWindow
d) Use the keypad to input a new Confirm Window time (between 01 and 60 minutes)
Note: For a multi-lock setup, repeat Steps 5a through 5d for each safe lock.
e) Success TD Updated appears on screen and the Keypad will beep three times and flash a green LED
once complete
3.11.1.2 Time Delay Count Mode – Display Keypad
For Entries with a display, there is an option to configure the time display for their respective time delay feature. Select
one of the following options:
1. Off.
2. Count Up.
3. Count Down.
Follow these steps to set the options:
1. Navigate through the Main Menu and select System.
2. Select TD Cnt Mode from the sub-menu.
3. Select either Delay Period or Confirm Window.
4. Select one of the following choices and press the return key:
a. Off
i. the time remaining or accumulated will not display; only information on what period it is in will be
displayed
b. Count Up
i. the count will start from 00:00 and count up until the period expires
c. Count Down
i. the time will start at the period length and count down to 00:00
3.11.1.3 Enable/Disable Time Delay – Non-Display Keypad
Note: This function is not available on the 701 series of Keypad,
Follow these steps to Enable/Disable Time Delay on a non-Display Keypad:
1. Using the Keypad, input #72 + Authorized ID and Combination + Delay Period (00 to 99 minutes) + Open Window
(01 to 60 minutes) + Return Key.
2. The Keypad will beep three times and flash a green LED once complete.