dormakaba USA Inc. System User Guide 7040.0321 | 5
1 Introduction
This guide outlines general information for using and programming LA GARD electric combination safe locks and all its
components, including accessories and software client. This guide assumes the installer has knowledge of electrical,
mechanical, and computer concepts, as well as having familiarity with safe lock systems and associated components. For
reliable and safe operation of the equipment, comply with all safety precautions outlined in this guide.
1.1 Approved Standards
The LA GARD family of safe locks conform to the following approved standards:
• UL 2058 (High Security Electronic Locks)
• EN 1300:2018 *Pending
• 705 Keypad – FCC ID: 2ASNP-705, IC ID: 24793-705
• DKLG70X FOB – FCC ID: 2ASNP-DKLG70X, IC ID: 24793-DKLG70X
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
• Consult the dealer or an experienced radio/TV technician for help
CET APPAREIL EST CONFORME À LA NORME RSS INDUSTRIE CANADA EXEMPT DE LICENCE. Son
fonctionnement est soumis aux deux conditions suivantes:(1) Cet appareil ne doit pas provoquer d’interférenceset(2) Cet
appareil doit accepter toute interférence, y compris les interferences pouvant causer un mauvais fonctionnement du
dispositif. Cet appareil numérique de la classe [B] respecte toutes les exigences du Réglement sur le matériel brouilleur
du Canada.
1.1.1 705 Keypad FCC & IC Info
Follow these steps to view the FCC & IC information on a 705 Keypad:
1. Enter the ID and Combination to access the menu.
2. Navigate through the Main Menu and select System.
3. Select FCC Label from the sub-menu.
4. Navigate through the FCC & IC information on screen with the arrow buttons.
1.2 Electrical Precautions
Ensure alkaline batteries (where applicable) are new and in good condition; leaking batteries can cause damage to
components and can also cause serious bodily harm. Do not apply power (where applicable) before completing all steps
of the installation; doing so may damage the components. Ensure all power supplies are plugged into grounded electrical
receptacles that comply with local building code(s). When AC mains power is required the power supply shall be installed
in accordance with NFPA 70 and any applicable electrical codes.
To Next Page