dormakaba USA Inc. System User Guide 7040.0321 | 32
3.11.5.2 Open Lock During Time Delay Using Override with Combo – Non-Display Keypad
Follow these steps to Open a lock during a Time Delay using Override w/ Combo on a Non-Display Keypad:
1. Using the Keypad, input the User ID and Combination.
2. If the lock has Time Delay Override enabled and the User has Time Delay Override w/ Combo privileges, the lock
will open.
3.11.6 Open Lock During Time Delay Using Override with FOB
This feature is only available on the Model 705. The Time Delay Menu is presented after User(s) entered valid
credential(s) while Time Delay is active. The Time Delay Menu will have a list of options that vary based on the type of
User and hardware options.
Options that may appear in the Menu as follows:
• Single Lock System
o Status
reports the time remaining in either the Delay Period or the Confirmation Window (Confirmation
Window is shown for a valid user without open privilege, e.g. Master or Audit Only User)
o Cancel
cancels the Time Delay for the lock
o FOB Override
only available if the Keypad has the BLE option AND the user accessing the Time Delay menu
possesses open privileges
prompts the user to present the FOB for overriding Time Delay; if FOB is authorized to override
the Time Delay, the lock is opened
o Notes
if the lock is in the Confirmation Window, and the user is authorized to open the lock, then the
lock will open, otherwise the user is shown the Menu (Example: an Audit Only User)
if the user is authorized to open the lock and possesses Time Delay Override privileges, the
lock will open after the credential Keypad during the Delay Period
• Multiple Lock System
o Status
provides list reporting for each installed lock and the status of the lock. The list can be
navigated through using the Up and Down keys. Will report the status as:
• Dly Disable
• Dly Inactive
o time Delay is enabled, but the lock is not in the Delay Period, nor the
Confirmation Window
• Delay: mm:ss
o the lock is in the Delay Period and shows the time in minutes and seconds, using
the Count Feedback mode assigned for the Delay Period
• Open: mm:ss
o the lock is in the Confirmation Window and shows the time in minutes and
seconds, using the Count Feedback mode assigned for the Delay Period
o Open Lock
the Master user does not see this option
the User is prompted to select a lock. Only locks which the user is authorized to open are
shown in the selection screen
• Selected Lock has Time Delay disabled
o the Lock will open
• Selected Lock has Time Delay, but it’s inactive
o if the Lock allows Time Delay Override and the user has Override privileges, then
the lock will open
o Time Delay will initiate for the selected lock
• Selected Lock is in the Delay Period
To Next Page