Input/Output menu
Select input source
Selects from which port the video source device is connected. When set to ‘Select
automatically’, the monitor automatically switches to an active input, if the current
input is not active.
NOTE: You can quickly cycle through the various input sources by pressing
the joystick up when the OSD menu is not active.
Volume
Adjusts the output volume for the built-in audio jack.
CAUTION: To reduce the risk of personal injury, adjust the source device
volume before using headphones, earbuds, or a headset.
Split-screen mode
Enables showing an image from two display input sources side-by-side. Also known
as ‘Picture besides picture mode’.
Secondary input source
Selects from which display input port the second image is shown in split-screen
mode. This setting is only available when ‘Split-screen mode’ is set to ‘On’.
Audio source
Selects from which of the two active input sources the audio is played in split-
screen mode. This setting is only available when ‘Split-screen mode’ is set to ‘On’.
USB Type-C port mode
Selects between maximum video signal bandwidth, or maximum USB hub data
bandwidth for the USB Type-C port.
maximum USB hub bandwidth
maximum refresh rate at 1440p
NOTE: To reach 280Hz refresh rate when USB-C bandwidth priority is set to
High USB data speed, your video source device must support display
stream compression (DSC).
HDMI port 1 mode
Selects between the maximum performance of HDMI 2.1, or maximum compatibility
with previous HDMI versions for HDMI port 1.
To Next Page
Loading...
Need help?
General
