SECTION 4 - TECHNICAL INFORMATION
4-64
SmartDate 5 08/08
4.9.14 Controller PCB to User Interface
The Interface between the Controller and User Interface is a combination of three
cables.
The function of these connections follows:
The User Interface Keypad connects via a 8-way single in line connector to X13
on the Controller PCB.
The Back light connects via two wires to 3-way 2.54mm Molex connector X14 on
the Controller PCB.
The LCD connects via a 20-way IDC ribbon cable to X15 on the Controller PCB.
4.9.15 Auxiliary Serial Comms Interface
A 9 way D type connector provides RS-232/485 comms.
This enables the SmartDate 5 printers to be communicated with on a point to
point basis (RS-232) or Networked together (RS-485)
4.9.16 Ethernet Interface
An Ethernet connection is provided as standard on the SmartDate 5 controller.
This connection can be used for Networking the SmartDate 5 printers or to
communicate with a SmartTouch user interface.
For connection and setup information see Section 3 - Installation.
To Next Page
Loading...