To Next PageTo Next Page
Need help?Do you have a question about the Dover Markem-Imaje SmartDate X60 and is the answer not in the manual?
General| Print Technology | Thermal Transfer |
|---|---|
| Print Area | 53 mm x 75 mm |
| Maximum Print Speed | 600 mm/s |
| Print Resolution | 300 dpi |
| Ribbon Width | 20 mm to 55 mm |
| Ribbon Length | 1100 m |
| Connectivity | USB, Ethernet |
| Ink Type | Thermal Transfer Ribbon |
| Power Supply | 90-240 VAC, 50/60 Hz |
Details the available SmartDate X60 printer types: Combined-Intermittent/Continuous and Continuous with shuttle.
Lists the main components of the SmartDate X60 and its key operational features.
Explains the Intermittent and Continuous printer types, including their print areas and speeds.
Details the LCD touchscreen and four-button hotkey interface, including available options.
Explains the four rubber push buttons below the screen used for starting, stopping, and job selection.
Explains the Home Screen as the main screen for starting operations, available as Ready or Producing Screen.
Provides instructions on how to start the printer to 'Producing' mode and stop it to 'Ready' mode.
Describes the Supplies Screen, providing information on ribbon remaining, prints, and remaining time.
Explains health metrics like Uptime, Downtime, and Ribbon Change Time, and how they are calculated.
Details settings for adjusting print darkness, offset, registration, rotation, and image parameters.
Provides instructions for removing the cassette, loading/replacing ribbons, and handling broken ribbons.
Explains the principles of printing, including Thermal Transfer Technology and the print process.
Details the different operating modes, including Non-Ribbon Save and Ribbon Save modes.
Covers options specific to printer types: Intermittent, Continuous, and Shuttle Continuous modes.
Explains High Speed Mode for throughput and Interlace Mode for ribbon saving with reduced contrast.
Details Radial, Digital, and Cost Saving Ribbon modes for efficient ribbon usage and cost reduction.
Covers machine-specific settings like type, carriage position, print modes, and security levels.
Covers print features like Print Mode, Substrate Speed, Print Speed, and Ribbon Save Mode settings.
Explains settings for starting printing, including Print Trigger, Debounce Time, Pack Length, and Spacing.
Details settings to control printed image quality, including Print Darkness, Contrast, and Head timing.
Covers encoder settings for continuous printers, including type, resolution, and speed warnings.
Details settings for adjusting print position, including Registration, Offset, Rotation, and print width.
Covers ribbon settings like grade, color, width, and monitoring features like break and low ribbon detection.
Details service options such as setup wizards, installation, factory restore, and firmware upgrades.
Details how to view printer status information, including serial numbers, sensor states, and orientation.
Explains how to test various printer functions manually, including ribbon and printhead controls.
Outlines recommended quick/regular checks (printhead, ribbon tracking) and monthly checks (rollers, belts).
Details printhead care, emphasizing regular cleaning, minimal air pressure, and minimum darkness settings.
Provides step-by-step instructions for removing damaged printheads (Combined and Shuttle types).
Explains how to set the correct printhead resistance, especially for non-Markem-Imaje printheads.
Details procedures for replacing the Peel Roller, Ribbon Guide Rollers, and Ribbon Movement Roller.
Explains the necessity of encoders for continuous printers, mounting, and recommended Quadrature encoder setup.
Provides detailed specifications for the SmartDate X60, including print area, speed, resolution, and power.
