Dover Markem-Imaje SmartDate X60 - Registration; Test Print of the Current Job

87 10056272-AA
 Registration
This is the position of the print relative to the direction of the substrate.
Increasing the registration will move the position of the print further back on the
substrate.
Print Adjust
Registration
0
Min = 0 mm; Max = 600 mm
Current Value: 0 mm
Registration
 Test Print of the Current Job
This option allows you to activate a test print of the current selected job.
To access the Test Print option:
From the Menu screen select Test Print.
Home
Print Adjust
Registra-
tion
Darkness
Offset
Test Print
Rotation
Print
Adjust
If the machine type is an Intermittent printer the print will be activated immediately.
If the machine type is a continuous printer the target material must be in motion for the
action to take place.
Operation
for parts & service call QLC (800) 837-1309