Interface
66 10056272-AA
Failed Prints
With Continuous printers there may be occasions where SmartDate X60 can not com-
plete a print because the production speed slows to a point where printing can not take
place.
If this happens you will be prompted with the option to manually discard the print or wait
until the production speeds up again.
The action taken if the print is not discarded will depend on the Low Speed Print Mode
setup.
May need to discard print
Wait or manually discard now?
It is important to note that this is an option and that waiting may correct the warning.
for parts & service call QLC (800) 837-1309
To Next Page
Loading...
