External links
235 10056272-AA
Print Go Input Wiring
Print Go Input using a voltage free contact
If a voltage free contact is used it should be wired between terminals 1 (24 V DC) and
2 (PRINT GO). SmartDate 5 is edge triggered and prints whenever the contacts close,
but will not print again until the contacts have opened and closed again after printing is
complete.
Print Go Input using a PNP sensor
If a PNP sensor is used connect as follows:
– Signal cable into terminal 2 (PRINT GO)
– Ground cable into terminal 3 (GND)
– Power cable to terminal 1 (+24 V)
SmartDate 5 prints each time the sensor changes from low state to high state.
The input draws a maximum of 13 mA at 25 VDC.
for parts & service call QLC (800) 837-1309
To Next Page
Loading...
