Printer configuration
167 10056272-AA
Ribbon Winding
Range: Inside Winding or Outside
Winding
Default: Inside Winding
Depending on which side of the ribbon the ink positioned, this allows you to
configure the Inside or Outside option.
Ribbon Advance Distance
Range: 1 - 10mm (1 - 1000 mm*100)
Default: 1mm
This allows you to set the distance the ribbon advances between prints (in
addition to the length of the print)
When using Radial Ribbon Save this should be set to a minimum of 2 mm.
Ribbon Spacer Width
Range: 0 to 55 mm
Default: 0
This allows you to configure the width of a ribbon spacer if one is being used.
Ribbon Extra Wind
Range: 0 to 600 mm
Default: 0
This allows you to configure the amount of additional wind on when a new
ribbon is fitted or the cassette is opened.
Ribbon Monitoring
The Ribbon Monitoring menu allows you to configure various settings related to the
condition of the ribbon.
The following Ribbon Monitoring options can be configured:
Setting Description
Ribbon Break Detection
Range: YES / NO
Default: YES
This allows you set the ribbon break detection function.
Low Ribbon Detection
Range: Yes / No
Default: Yes
This allows you to set the low ribbon detection function.
Low Ribbon Size
Range: 10 - 100m
Default: 10m
This allows you to set the point at which the Low Ribbon warning is activated.
When the remaining ribbon is less than this value, and the printer is in
Producing mode, the Status LED changes to Amber and the Low Ribbon
warning is displayed.
A value of 0 m disables the Low ribbon sensing.
Low Ribbon Action
Range: Warning or Fault
Default: Warning
Raise warning or raise fault.
for parts & service call QLC (800) 837-1309
To Next Page
Loading...
