Printer configuration
165 10056272-AA
Print Position
The Print Position menu allows you to fine tune the position of the print on the target
material.
The following Print Position options can be configured:
Setting Description
Registration
Range: Continuous 0.0 - 600.0mm
Intermittent 0.0 - 75.0mm
Default: 0mm
This is Continuous printer feature.
This allows you to set the start position of the print relative to the Print Go
position.
Intermittent printers
This allows you to set the start position of the print module.
Registration Adjust
Range: -10mm to +10mm
Default: 0mm
This allows you to set a printer specific registration level for the printer.
If a Job includes a registration setting this may produce different positioned
prints on individual machines.
This adjustment compensates for any differences.
Pre print Delay
Range: 0 to 50
Default: 0
This is Continuous printer feature.
This allows you to set the length of delay applied at the start of the print cycle.
Offset
Range: 0 to ribbon width
Default: 0mm
This allows you to adjust the print position perpendicular to the direction of
print. (Across the printhead)
Print Delay
Range: 0 to 5000 ms
Default: 0 ms
This is an Intermittent printer option
This allows you to define the time between the Print Go signal and the start of
the print.
Rotation
Range: 0 or 180°
Default: 0
This allows you rotate the image through 180°
Maximum Print Width
Range: 0 to 55 mm
Default: 55 mm
This is used in conjunction with a ribbon spacer, where it is necessary to limit
the amount of usable ribbon.
Print Position Tolerance
Range: 0 or 10 mm
Default: 2 mm
This is Continuous printer feature.
This allows you to configure the position tolerance of the print on the
packaging.
A higher value here allows smaller gaps between the prints on the ribbon.
for parts & service call QLC (800) 837-1309
To Next Page
Loading...
