Printer configuration
171 10056272-AA
Master / Slave
The Master / Slave function allows up to four additional SmartDate X60 printers to be
controlled from a single Master SmartDate X60.
Once the Slave printers are configured, a Job selected on the Master will also be
selected on the Slave printers.
Setting Description
Number of Slaves
Range: 0 or 4
Default: 0
This allows you to set a second SmartDate printer to be controlled by the
master SmartDate
Slave IP Address
Range: Input by user
Default:000.000.000.000
This allows you to input the IP address of the Slave printer
Synchronise Start/Stop
Range: Yes or No
Default: No
When set to Yes the master printer will automatically activate Producing mode
on the Slave when the Start button on the master is pressed.
Logging
The Logging menu allows you to configure the Log file options.
The following Logging options can be configured:
Setting Description
Variable Data Log Level
Range: Job Selection/Update, Per
Print or None
Default: Job Selection/Update
This allows you to define what is logged in the variable data log.
Data Log Full Action
Range: Stop Logging Delete Old Data
or Stop Printing
Default: Stop Logging
This allows you to define what action will be taken if the log becomes full.
Event Log Level
Range: Full, Warnings Faults and
Information or Faults and Information
Default: Full
This allows you to define which data you require for logging.
for parts & service call QLC (800) 837-1309
To Next Page
Loading...
