92 10056272-AA
Loading a New Ribbon
1
Fit a new waste take up core and load a new ribbon following the web pattern shown inside
the cassette. (New ribbon on the red reel)
2
Remove sufficient ribbon from the new roll to make it unnecessary to pull additional ribbon
while the cassette is partially loaded. This makes loading easier and, in extreme cases,
prevents damage to the printer cassette.
3
Ensure that there are no creases in the ribbon by rotating the take up reel by hand.
4
Ensure that the ribbon is tracking parallel on the cassette rollers and is positioned correctly.
The ribbon must be loaded so that it is only in contact with the movable parts of the rollers.
5
Ensure that the ribbon is wound forward enough so that the transparent lead section is not
under the printhead.
Operation
for parts & service call QLC (800) 837-1309
To Next Page
Loading...
