94 10056272-AA
Re- Connecting a Broken Ribbon
If a ribbon break occurs the following procedure should be used:
1
Do not tie a knot to re-connect the ribbon.
2
Wind the remaining waste ribbon onto the waste core.
3
Pull some of the unused ribbon from the ribbon supply and wind it onto the waste ribbon
take up.
4
Turn the waste reel by hand at least one revolution and keep the join between the two as flat
as possible.
Failure to follow this procedure may cause unacceptable eccentricity on the
waste ribbon take up reel. This cannot be controlled by the printer and will
produce ribbon tension problems.
Operation
for parts & service call QLC (800) 837-1309
To Next Page
Loading...
