76 10056272-AA
Supplies
The Supplies Screen provides information about the available ribbon and number of
prints that can be completed before a ribbon change is required.
When the printer is in producing mode the remaining time will also be displayed with
respect to the current print cycle time.
The Supplies Screen
Diagnostics
Supplies
Ribbon Remaining
98%
Remaining Prints
1801880
Remaining Time
2 hours 20 mins
The Supplies monitoring screen can be accessed from either the Home screen, by
pressing the supplies bar or from the Diagnostics menu.
The following information can be viewed:
Percentage Ribbon Remaining
This figure shows the percentage amount of ribbon left on the supply reel. The value is
calculated and updated approximately every one hundred prints.
Remaining Prints on Ribbon
This is calculated as the number of prints that can be completed with the existing ribbon
prior to requiring replacement. This calculation is based on the assumption that the
current job settings and rate of production are held constant.
Remaining Time
This figure shows the amount of time left until the ribbon runs out. The calculation of this
figure is based on the assumption that production continues at the current pack rate,
with the same length of image and settings values affecting the ribbon usage.
This time is calculated and updated every ten seconds.
Operation
for parts & service call QLC (800) 837-1309
To Next Page
Loading...
