Dover Markem-Imaje SmartDate X60 - Jobs

Description
32 10056272-AA
 Jobs
SmartDate X60 uses Job Files.
Jobs are a combination of a Product Code, Image Template and a Device Settings File.
A Device Settings file is used to configure the device parameters to suit a particular set
of conditions.
For example:
Job A may be printing onto a Polypropylene substrate at a relatively slow print speed.
Job B may be printing onto a Metalized Polypropylene substrate at a much faster print
speed.
The Printer (Device) setup for each job will be different.
In many cases the Job may only require a default Image Template and default Device
Settings File.
When a Job is downloaded to the SmartDate X60 the data is stored as a .job file and
includes a .image file and a .settings file.
The Job Name would normally be the same as the Product Code but can be different if
required.
This is the name that is requested when performing a SELECT JOB command.
Job creation is performed with CoLOS Create Pro.
NOTE: When after selecting jobs in producing mode, there will be a short period of
time (order of 1 sec) during which printing will be disabled while the system is
updated to print the new image.
for parts & service call QLC (800) 837-1309