209 10056272-AA
Setting the correct printhead resistance
NOTE: with Smarthead printheads the resistance setting is automatic.
NOTE: the resistance value is printed on the PCB side of the new Printhead. This
value must be entered into the controller menu structure if a non Markem-
Imaje printhead is used..
The processor will then adjust the voltage level to suit the particular printhead resistance
level.
Each Printhead has an individual Resistance level, and the voltage level setting required
for each is different.
A label on the printhead displays the rating for that particular one.
In this case, R = 1272
The Printhead resistance option can be accessed from the Service menus.
The Security must be set to Enabled for the Service options to be displayed.
To access the Service Menu:
Select Menu and enter the appropriate password.
The Menu screen is displayed.
1
Home
Menu
Settings Service
Version
Information
Diagnostics
Statistics
Files
From the Menu screen select Service..
Maintenance
for parts & service call QLC (800) 837-1309
To Next Page
Loading...
