Printer configuration
160 10056272-AA
Print Features
The Print Features menu allows you to configure various settings that relate to the
operation of the printer.
The following Print Features options can be configured:
Print Mode
Range: High Pack Rate, High Speed
or Digital Ribbon Save mode
Default: High Pack Rate
This is a Continuous printer feature.
This allows you to set the printing mode to suit the customers requirements.
(See Operation for details)
Maximum Substrate Speed
Range: 100 mm/s to 1000 mm/s
Default: 600 mm/s
This is a Continuous printer feature.
This allows you to set the maximum substrate speed that the printer can
achieve a good quality print. Setting this value too high can result in distorted
prints.
(See Operation for details)
Print Speed
Range: 70 to 600 mm/s
Default: 100 mm/s
This is an Intermittent printer feature.
This allows you to set the print speed for Intermittent printers.
Return Speed
Range: 10 to 600 mm/s
Default: 100 mm/s
This is an Intermittent printer feature.
This allows you to set the speed of the printhead carriage during the return
part of the print cycle. This also sets the ribbon wind speed.
Min Print Speed
Range: 0 to 200 mm/s
Default: 70
This is a Continuous printer feature.
This allows you to set the minimum print speed for continuous printers.
Ribbon Save Mode
Range: No Ribbon Save, Interlaced,
Radial Mode 1 and Radial Mode 2
Default: No Ribbon Save
This allows you set the type of ribbon save function that you require. (See
Operation for details)
Relative Print Maximum Travel
Range: 0.0 mm to 30.0 mm
Default: 0.0 mm
This is a Combined printer continuous mode feature.
This allows you to set the maximum distance that the printhead module can
move to complete a print if the host machine stops during the print cycle.
(See Operation for details)
for parts & service call QLC (800) 837-1309
To Next Page
Loading...
