Printer configuration
156 10056272-AA
Machine Options
The Machine menu allows you to configure various settings that are specific to the
particular printer.
The following Machine options can be configured:
Macine Type
Range: Continuous or Intermittent
Default: Continuous
This allows you to configure the Smartdate X60 to Continuous or Intermittent
operating mode.
Carriage Position
This allows you to set the position of the printhead module carriage when in
continuous operating mode.
Prompt for Ribbon
Range: Yes, No
Default: Yes
This allows you to enable the ribbon type prompt.
When set to YES the user must enter a ribbon type when changing ribbon.
Low Speed Print Mode
Range: None, Continue or Reprint
Default: None
This is a Continuous printer function.
This allows you to set which action should be taken if the host machine speed
drops below the Low Speed Threshold.
Discard Print Time
Range: 0 - 30s
Default: 0s
This is a Continuous printer function.
This allows you to set the time that the substrate must be stationary during a
print before the print is discarded.
Security Level
Range: Open or Medium
Default: Open
This allows you to set a password level for your machine. Access codes are
configured with CoLOS Control.
Database Level
Range: Local or Host
Default: Local
This allows you to select between using the local machine database or a
remote host PC.
for parts & service call QLC (800) 837-1309
To Next Page
Loading...
