Printer configuration
157 10056272-AA
Job Queuing
Range: Off, On, Repeat or Binary
Select
Default: Off
This allows you to queue up to eight jobs to be printed in a sequence. For
example: These jobs may have an allocation of 20 prints before the next job is
selected. If repeat is selected each job in the queue will be printed once in the
sequence.
Binary allows the jobs to be selected remotely and in any order from the
queue.
Pack Rate Period
Range: 1 to 24 hours
Default: 1 hour
This allows you to set the time period over which the average pack rate is
measured.
Power Saving Timer
Range: A user selected time or Off
Default: Off
This allows you to set a time before power saving is activated.
This de-energises the motors and printhead until power saving is de-activated.
Prompt for Allocation
Range: Yes or No
Default: No
This allows you to enable the allocation prompt fuction
After selecting a job the user will be asked how many allocated prints are
required
Default Allocation
Range: 0 to 999999
Default: 0
This allows you to allocate a default number to prints as a standard setting.
for parts & service call QLC (800) 837-1309
To Next Page
Loading...
