Dover Markem-Imaje SmartDate X60 - Maintenance; Replacing the Printhead; Removing the Damaged Printhead (Combined)

205 10056272-AA
 Replacing the Printhead
The SmartDate X60 printhead can be changed quickly and easily.
Turn off the power to the controller and isolate the air supply to the printer body.
Remove the ribbon cassette.
Always ensure anti static precautions are used when handling new printheads.
 Removing the damaged printhead (Combined)
1
Push the printhead forward towards
the peel roller and rotate the rear of the
printhead outwards as shown above.
2
Disconnect the ribbon cable from the
printer interconnection PCB.
3
Push the printhead forward towards
the peel roller and rotate the rear of the
printhead outwards as shown above.
Maintenance
for parts & service call QLC (800) 837-1309