SECTION 3 - MAINTENANCE
3-11
SmartDate 5 06/08
3.7 Replacing the Peel Roller
The Peel Roller body is a wear part and should be checked for damage and
changed if necessary.
1. Remove the retaining screw from
the end of Peel roller.
4. Clean off any excess fluid and
ensure the roller is free to rotate.
3. Fit a new Peel roller body over the
shaft and secure the screw with
Loctite 222.
2. Remove the screw and washer and
lift off the roller body.
To Next Page
Loading...