SECTION 3 - MAINTENANCE
3-21
SmartDate 5 06/08
3.14 Replacing the Drive Belts
The Combined printer and Shuttle printer drive belts can become worn or
damaged after long periods of running. The belt should be checked at regular
intervals for wear or damage.
If the belt has to be replaced, the procedure is as follows:
3.14.1 Replacing the Drive Belt - Combined Printer
1. Remove the four retaining screws
from the print module.
2. Pull the module upwards off the
key and move it out of the way.
3. Remove the securing screws from
the print module carriage belt clamp.
4. Loosen off the belt tensioner
screws.
To Next Page
Loading...