SECTION 3 - MAINTENANCE
3-4
SmartDate 5 06/08
3.3.2 Monthly Checks
• Check condition of peel roller: Remove roller and inspect internally for wear.
Replace if necessary.
• Check condition of the ribbon guide rollers: Check that bearings are smooth.
• Check the condition of the shuttle rollers (SmartDate 5s).
• Check condition of ribbon sensor roller. Inspect the roller coating for wear and
damage. If worn or damaged, replace the roller.
• Ensure all rollers are square to the Cassette or Printer.
• Check the magnet for any damage or non-alignment. This magnet is used for
ribbon detection and ribbon calibration.
• Print a test image to check printhead quality and alignment. See Section 6 -
Menus.
• Check condition of printhead/ shuttle carriage drive belt and associated
components: pulleys, bearings, retainers and shafts.
• Check Air cylinder.
To Next Page
Loading...