SECTION 3 - MAINTENANCE
3-37
SmartDate 5 06/08
3.20 Replacing the Controller PCB
If the Controller PCB has to be replaced, the procedure should be as follows:
Switch off and disconnect the power to the printer.
2. Remove the four retaining screws
from the Controller cover.
1. Remove the six retaining screws
from the D type connectors.
3. Lift off the Controller cover. 4. Disconnect the various connectors
from the PCB.
Caution: Anti static precautions should be adhered to when
handling PCB,s
To Next Page
Loading...