3.1.7 Install a DPC Interface in a Terminal Pedestal (for Wayne and Gil-
barco)
F M S P a r t Number 20-4419-DPC
DANGER: To prevent the possibility of electrical shock, de-energize the AC Power
Supply before you do the installation procedure shown below.
A DPC board can also be installed in a terminal pedestal when an FSC3000 is installed in the terminal.
3.1.7.1 20-4428 Board Plate Assembly Installation
You will first need to install a 20-4428 Pedestal Board Plate.
NOTE: The illustrations show installation with a PV200 terminal. Installation with a PV100
and PV300E are the same.
l Remove the four (4) 50-0008 8-32 KEPS nuts from the studs on the inner back wall of the pedestal.
l Align the holes of the 20-4428 Plate with the studs to put the plate in its correct position. The holes
at the bottom of the plate are slotted for easier installation.
l Put the 50-0008 nuts back on the studs and tighten them to complete the installation of the plate.
M1700 FSC3000 Installation Manual | Dover Fueling Solutions 54
To Next Page
Loading...