3.1.7.2 Pedestal Mount DPC Kit Installation (FMS P/N 20-4419-DPC)
Part # Part Description
20-0612 Electronic Pump Handle Monitor Assembly
20-1618 Cable, PCM Master
12-3004 Cable, RJ45 to RJ45
54-0439 DPC Jumper Setup Label
1. Install the DPC Interface Board.
l Remove the four (4) top 8-32 KEPS nuts from the top left set of studs of the Pedestal Board Plate.
l Align the 20-0612 board with the studs.
l Put the 8-32 KEPS nuts back on the studs and tighten them.
M1700 FSC3000 Installation Manual | Dover Fueling Solutions 55
To Next Page
Loading...