l Put the other end of the cable through an open knockout hole in the bottom of the terminal.
l The routing of the cable should be around the inside of the terminal so it is out of the way of internal
components.
6. Connect the other end to RS-232 Port 4 of the FSC.
INFORMATION: The illustration above shows the ports as they are seen from the top of the
FSC3000. Port 4 is the one on the left of the back row of RS-232 ports.
7. Install the pump communication wiring to the converter as shown in the illustration "" on page 58.
3.1.9 Physical Configuration
Set up jumpers to match the pump type to be connected. See the Wayne/Gilbarco Jumper Settings
illustrations below.
When a jumper is set as "ON" this means the jumper will tie both pins together.
When "OFF," the jumper should be set on one pin.
Some jumpers have three pins; when the jumper says "Pins 1-2" this means the jumper should be set on
Pins 1 and 2 of the 3-pin jumper.
On 3-pin jumpers the board is labeled to indicate which pin is number one.
3.1.9.1 DPC Interface Jumper Setup (for Wayne and Gilbarco)
M1700 FSC3000 Installation Manual | Dover Fueling Solutions 61
To Next Page
Loading...