Dr.coffee F08 - Drip Tray Is Not in Place; Drip Tray Is Full up; Coffee Thermo-Block Over-Heated

Rev 0.0
Dr.coffee Service Manual 28
8.1.4 Drip Tray Is Not In Place
Name
Showing on the Screen Cause Solutions
Drip Tray
Is Not In
Place
a) Not well fixed;
b) Sensor broken ;
c) Magnet loosing or broken;
 Replace the drip tray;
 Replace new sensor;
 Replace new magnet;
8.1.5 Drip tray is full up
Name
Showing on the Screen Cause Solutions
Drip tray
is full up
a) The waste water in the tray is full;
b) Sensor is dirty;
 Pull out and empty the tray;
 Check and clean up the sensor;
8.1.6 Coffee Thermo-Block Over-heated
Name
Showing on the Screen
Cause
Solutions
Coffee
Thermo-
Block
Over-he
ated
a) Temperature is over 160℃;
 Wait, as the tips in the Screen “The hot
water thermos-block is cooling down,
please wait ...”;
 While the thermos-block is cooling down,
no beverage could be made.
Technicup Service Manual