Ceiling and wall attachment
Dr. Mach
Lamps and Engineering
• Loosen the two screws S with a cross-head
screw driver.
• Remove the white covering caps AK at the
bracket.
• Remove the subjacent brake screws B with a big
screw driver.
• Spread the two covering plates AS by using a
screw driver.
6.1.3 Electrical connection
Attention!
If the cables at the plug are damaged, the exten-
sion arm is under a voltage of 230V.
Install the plug carefully.
AS
6
5
59500001 Edition 06 11.03.2003 / Bak Page 26/48
To Next Page
Loading...
