REPLACEMENT PROCEDURES (continued) NM2C
4.17.20 Join the lamp connector to J2 on the bottom board of the power
supply.
Power Indicator Lamp Wire Connections to J2:
TERMINAL WIRE COLOR
1 Black
2 Red
4.17.21 Reinstall the power supply compartment to the frame rails with the
hardware that was previously removed.
4.17.22 Reinstall the power supply compartment cover with the four screws
that were previously removed.
4.17.23 Reinstall the bottom and center cabinet drawers. Ensure that their
locking tabs are correctly in place.
4.17.24 Enable the circuit breakers and restore power to the machine.
4.17.25 Perform the PMS Procedure given in Section 6.
4-55A Rev. A
RETURN TO CD-ROM TABLE OF CONTENTS
RETURN TO THIS MANUAL'S TABLE OF CONTENTS
To Next Page
Loading...
