67
The menu » Settings «
– Test fault
— This function simulates the fault alarm state for testing purposes.
Select the menu items » Settings «, » Instrument «, » Alarm « and » Test
fault alarm « in this order, pressing the » « key after each selection.
— The function » Test fault status « is opened.
Select » Enable « or » Disable « and press the » « key to activate.
— When the function is enabled, the relay and the interfaces are set to the
fault alarm state.
Passwords
This group contains the setting functions for the passwords.
– Password Calibration
— This function is used to change the password for the menu » Calibration «.
Select the menu items » Settings «, » Instrument «, » Passwords « and
» Password Cal. « in this order, pressing the » « key after each selec-
tion.
Select the line for password input and press the » « key to switch to edit
mode.
Use the » « and » « keys to set each position of the password and
press the » « key to confirm the setting.
Press the » « key to confirm the complete password.
– Password Settings
— This function is used to change the password for the menu » Settings «.
Select the menu items » Settings «, » Instrument «, » Passwords « and
» Password Cfg. « in this order, pressing the » « key after each selec-
tion.
Select the line for password input and press the » « key to switch to edit
mode.
Use the » « and » « keys to set each position of the password and
press the » « key to confirm the setting.
Press the » « key to confirm the complete password.
Date and time
— This function is used to set the date and / or time.
Select the menu items « Settings «, « Instrument « and « Date and time «
in this order, pressing the » « key after each selection.
Select the desired input line (Date or Time) and press the » « key to
switch to edit mode.
Use the » « and » « keys to set the value and press the » « key
to confirm the setting.
OK
OK
OK
M
To Next Page
Loading...
Need help?
General