Start-up
38
Start-up
Switch on power supply.
The transmitter begins its warm-up routine:
— Depending on the type of sensor installed, the warming-up period time may
last between 5 minutes and 12 hours. See the related information in the op-
erating instructions for the sensor. The warm-up phase may take longer in
extremely high or low temperatures.
When the sensor has warmed up:
Calibrate sensor, page 44, when a pre-calibrated sensor is not used.
— Transmitter is ready for use.
Check the transmission of the signals between to the control unit and the
initiation of alarms, see the function group » Analogue interface « on
page 71.
— The software version, the date and the time are displayed.
NOTE
For the correct operation and functionality it is important to set the date
and time.
— The sensor is now warming up. The remaining warming-up time for the
sensor is displayed.
NOTE
Note on the operation with relay module:
During the warm-up period, the relay module indicates a fault. Alarms A1
and A2 are not indicated during the warm-up period.
— The sensor is ready for use.
Pioneering Solutions
Polytron 7000
A001_en.eps
A003_en.eps
SWversion: 8.0
29.10.11 11:47
A004_de.eps
H
2
S
ppm
in 00
:
01
:
30
Sensor ready
A005_en.eps
H
2
S
ppm
0.0
To Next Page
Loading...
Need help?
General