Need help?Do you have a question about the DRAKE R8A and is the answer not in the manual?
Details on setting the correct voltage and fuse for safe operation.
Instructions for safely removing the receiver from its packaging.
Steps for setting up the receiver in a permanent location.
Instructions for installing and operating the receiver in a vehicle.
Information on selecting and connecting appropriate antennas.
Serial port for computer control and data transfer.
Procedure for resetting the receiver's microprocessor.
Explanation of how RF gain, AGC, and signal meter interact.
Detailed explanation of the interplay between gain controls and the signal meter.
Steps for storing frequencies and other data into memory channels.
Methods for retrieving stored memory information.
Procedure to remove stored memory channels.
How to clear all stored memory locations at once.
How to lock or unlock specific memory channels.
How to initiate a scan of all unlocked memory locations.
Organizing memory locations into blocks for scanning.
Performing a scan between two specified frequency endpoints.
Detailed steps for setting the local and alternate time clocks.
How to use the two programmable timers for automatic ON/OFF control.
Procedure for programming the start and end times for timers.
How to activate or deactivate the programmed timer functions.
Procedure to erase all programmed memory channels.
Explains special messages displayed by the receiver and their meanings.
Details of the product's limited warranty coverage and terms.
To Next Page
General
