Dru Virtuo Evolve 100 - Platform Combined with Lower Decorative Strip; Platform Adjacent to the Glass

16
7.3.1 Platform combined with lower decorative strip
Virtuo 100, Virtuo 130, Virtuo 180
1 Create a recess in the platform, in which the appliance will be placed. (see g. 7-13 A and C for options and Dimensions).
1 Mutually adjust the height of the appliance and assembly set, so that the top side of the platform connects to the bottom
side of the lower decorative strip.
Virtuo 100/3, Virtuo 130/3, Virtuo 180/3
1 Create a recess in the platform, in which the appliance will be placed. (g. 7-14 A and C) for options and dimensions.
3 If a false wall is used, the recess will be less deep.
1 Adjust the height of the appliance, so that the top side of the platform connects to the bottom side of the lower
decorative strip.
7.3.2 Platform adjacent to the glass
To connect the platform to the glass pane, the decorative strip should be lowered. Take the following into account:
3 - Make sure that the end of the decorative strip remains level (g. 7-11 steps 2 and 3).
- Do not allow the weight of the platform to rest on the appliance and/or the adjustable prole.
- Make sure there is 5 mm space between the platform and the springy glass pane strip.
Virtuo 100, Virtuo 130, Virtuo 180
1 Create a recess in the platform, in which the appliance will be placed. Maximum material thickness is 30 mm.
(g. 7-13 B and D) for options and dimensions.
1 Remove the Allen screws on both sides of the lower decorative strip. (g. 7-11 step 1)
1 Lower the lower decorative strip (see g. 7-8 step 2) by loosening the screws by a few turns. Place the lower decorative
strip at the required height and tighten the screws again.
1 Remove the centring ring at the bottom of the vertical decorative strip by breaking it o at the front (g. 7-11 step 3)
Virtuo 100/3, Virtuo 130/3, Virtuo 180/3
1 Create a recess in the platform, in which the appliance will be placed. The maximum material thickness is 30 mm
(g. 7-14 B and D) for options and dimensions.
3 If a false wall is used, the recess will be less deep.
1 Lower the lower decorative strip (see g. 7-12 step 1) by loosening the four screws by a few turns. Place the lower
decorative strip at the required height and tighten the screws again.
1 Remove the centring ring at the bottom of the vertical decorative strip by breaking it o at the front (g. 7-12 step 2)
Installation manual