Dru Virtuo Evolve 100 - Back and Side Wall Adjacent to the Glass of the Side Pane

20
38C-2845-01
2x
2x
1
2
3
7-15
7.3.3 Back and side wall adjacent to the glass of the side pane
3 - Where materials are installed up to the glass, heat-resistant material capable of withstanding temperatures of at least
85C. must be used.
Virtuo 100, Virtuo 130 and Virtuo 180
Side wall adjacent to the glass:
1 Remove the vertical decorative strip on the left and right side by removing the 2 recessed-head screws and 2 self-tapping
screws (g. 7-15 Steps 1 and 2).
1 Remove the centring block at the ends of the upper and lower decorative strip by cutting into it and breaking it o
(see g. 7-15 step 3).
1 Make sure the side wall to be placed has the correct dimensions (g. 7-17).
1 Repeat the above-mentioned steps for the other side, if applicable for the conguration.
3 Ensure a minimum space of 5mm between the wal
Virtuo 100/3, Virtuo 130/3 and Virtuo 180/3
Back wall adjacent to the glass:
1 Move the vertical decorative strip (g. 7-16 Steps 1 and 2) by loosening the two bolts by a few turns. Place it at the
required depth and tighten the bolts again.
1 Make sure the back wall to be placed has the correct dimensions (g. 7-18 Step 1).
1 Place the wall between the upper and lower decorative strip (see g. 7-18 Step 2).
1 Repeat the above-mentioned steps for the other side, if applicable for the conguration.
3 Ensure a minimum space of 5mm between the wall and the glass pane.
installatie- en gebruikershandleidingInstallation manual