06
110
Driving
- With an automatic gearbox: with the brake
pedal depressed until the vehicle stops or
the gear selector in position N, with the
vehicle stopped.
Time counter
A time counter adds up the time spent in
standby during the journey. It is reset to zero
every time the ignition is switched on.
Special cases:
The engine does not go into standby in the
following cases.
- Steep slope (rising or falling).
-
Needed to maintain a comfortable
temperature in the passenger compartment.
- Demisting active.
In these cases, this indicator lamp
flashes for a
few seconds, then goes
off.
Restarting the engine (START
mode)
The engine automatically restarts as soon as
the driver indicates the intention of moving off
again.
F
With a manual gearbox: with the clutch
pedal fully depressed.
F With an automatic gearbox:
•
With the selector in position D or M: with
the brake pedal released.
• With the selector in position N and the
brake pedal released: with the selector at
D or M.
•
With the selector in position P and the
brake pedal depressed: with the selector
at R, N, D or M.
•
Reverse gear engaged.
Special cases
The engine restarts automatically in the
following cases.
- With a manual gearbox: vehicle speed
exceeds 2.5
mph (4 km/h),
-
With an automatic gearbox, in mode N,
vehicle speed exceeds 0.6 mph (1 km/h),
In these cases, this indicator lamp
flashes for a few seconds, then goes
off.
Malfunctions
In the event of a malfunction,
this warning lamp flashes for
a few moments, then remains on,
accompanied by the display of
a message.
F Have the vehicle checked by a dealer or
a
qualified workshop.
The vehicle stalls in STOP mode
All of the instrument panel warning lamps come
on if this fault occurs.
F Switch off the ignition then start the engine
again with the "START/STOP" button.
The Stop & Start system requires a 12 V
battery of specific technology and
specification.
All work concerning the battery must be
carried out only by a dealer or a qualified
workshop.
After the engine has restarted, STOP mode
is not available as long as the vehicle has
not reached a speed of 5 mph (8 km/h).
During parking manoeuvres, STOP mode
is not available for a few seconds after
coming out of reverse gear or turning the
steering wheel.
Tyreunder-ination
detection
This system automatically checks the
pressures of the tyres while driving.
It compares the information given by the wheel
speed sensors with reference values, which