DS Automobiles DS 3 CROSSBACK User Manual

04
74
Lighting and visibility
Changing a wiper blade
Removing/rettingatthefront
Do not touch the wiper blades – risk of
irreparable deformation.
Do not release them while moving them –
risk of damaging the windscreen!
F
Clean the windscreen using screenwash
fluid.
Do not apply "Rain X" type water-repellent
products.
F
Unclip the worn wiper blade closest to you
and remove it.
F Install the new wiper blade and clip it to the
arm.
F Repeat the procedure for the other wiper
blade.
F Starting with the wiper blade closest to
you, once again hold each arm by the rigid
section, then fold it carefully, guiding it to
the windscreen.
Removing/rettingattherear
F Hold the arm by the rigid section and raise it
as far as possible.
F Clean the rear screen using screenwash
fluid.
F Unclip the worn wiper blade and remove it.
F
Install the new wiper blade and clip it to the
arm.
F Once again hold the arm by the rigid
section, then fold it carefully, guiding it to
the rear screen.
F
Carry out these wiper blade replacement
operations from the driver's side.
F Starting with the wiper blade farthest from
you, hold each arm by the rigid section and
raise it as far as possible.
Automatic windscreen
wipers
In AUTO mode, the windscreen wipers operate
automatically, without any action on the part of
the driver. If rain is detected, the wiping adapts
to the intensity of the rainfall automatically.
Detection of rainfall is by means of a rain/
sunshine sensor at the top centre of the
windscreen, behind the rear view mirror.
Do not cover the rain/sunshine sensor.
When using an automatic car wash, switch
off the automatic wipers and the ignition.
In winter, wait until the windscreen is
completely clear of ice before activating
the automatic wipers.

DS Automobiles DS 3 CROSSBACK Specifications

General

Brand	DS Automobiles
Model	DS 3 CROSSBACK
Category	Automobile
Language	English