DS Automobiles DS 3 CROSSBACK User Manual

04
73
Lighting and visibility
Rear wiper
To select the rear wiper: turn the ring to place
the desired symbol against the marking.
Reverse gear
Off.
Intermittent wiping.
Wash-wipe.
Turn the ring fully; the rear screenwash and
wiper operate for as long as you hold the
ring turned. Termination of the screenwash is
followed by a final wiping cycle.
When reverse gear is engaged, the rear wiper
will come into operation automatically if the
front windscreen wipers are operating.
The function is activated or
deactivated in the Driving/Vehicle
menu of the touch screen.
In the event of accumulation of snow or
hard frost or if a bicycle carrier is fitted to
a
towing system, deactivate the automatic
rear wiper via the Driving/Vehicle menu
of the touch screen.
Special position of the
windscreen wipers
This maintenance position is used for cleaning
or replacement of the wiper blades. It can also
be useful, in winter (ice, snow), to release the
wiper blades from the windscreen.
This function is activated by default.
To maintain the effectiveness of the flat
wiper blades, it is advisable to:
-
handle them with care,
-
clean them regularly using soapy
water,
- avoid using them to retain cardboard
on the windscreen,
-
replace them at the first signs of wear.
Before removing a front wiper blade
F Within one minute of switching off the
ignition, any operation of the wiper control
stalk will position the wiper blades vertically.
F
Proceed with the desired operation or the
replacement of the wiper blades.
Afterrettingafrontwiperblade
F To return the wiper blades to their initial
position, switch on the ignition and operate
the wiper control stalk.

DS Automobiles DS 3 CROSSBACK Specifications

General

Brand	DS Automobiles
Model	DS 3 CROSSBACK
Category	Automobile
Language	English