04
72
Lighting and visibility
Do not operate the wipers on a dry
windscreen. Under extremely hot or cold
conditions, ensure that the wiper blades
are not stuck to the windscreen before
operating the wipers.
With manual wiping
With AUTO wiping
Windscreen wipers
To select the wiping speed: raise or lower the
stalk to the desired position.
Fast wiping (heavy rain).
Single wipe (press down and
release).
or
Automatic.
Refer to the corresponding section.
In position 1 or 2, the wiping frequency is
automatically reduced when the speed of
the vehicle drops below 3 mph (5 km/h).
When the speed is above 6
mph (10 km/h)
again, the wiping frequency returns to the
original frequency (fast or normal).
If the ignition has been switched off with the
windscreen wiper active, it is necessary to
operate the control stalk to reactivate the
wiping when the ignition is switched on (unless
the ignition is off for less than 1 minute).
Single wipe
F Pull the stalk briefly towards you.
Front screenwash
F Pull the wiper control stalk towards you and
hold.
The screenwash and windscreen wipers
operate for as long as the control stalk is
pulled.
Termination of the screenwash is followed by
a final wiping cycle.
With automatic air conditioning, any
action on the screenwash control results
in temporary closure of the air intake
to avoid odours inside the passenger
compartment.
To avoid damaging the wiper blades,
do not operate the screenwash if the
screenwash reservoir is empty.
Only operate the screenwash if there is no
risk of the fluid freezing on the windscreen
and hindering visibility. During the winter
period, use "very cold climate" rated
products.
Never top up with water.
Normal wiping (moderate rain).
Intermittent wiping (proportional to
the speed of the vehicle).
Off.
To Next Page
Loading...
Need help?
General
