02
40
Access
Changing the battery
A message is displayed in the instrument panel
when the battery needs changing.
Battery ref.: CR2032/3
Volts.
F
Unclip the cover by inserting a
small
screwdriver in the slot and raise the cover.
F
Remove the discharged battery from its
housing.
F
Insert the new battery, observing the
polarity, and clip the cover onto the housing.
F
Reinitialise the remote control.
For more information on Reinitialising the
remote control, refer to the corresponding
section.
Do not throw the remote control batteries
away, they contain metals which are
harmful to the environment. Take them
to an approved disposal point.
Reinitialising the remote
control
Following replacement of the battery or in
the event of a
fault, it may be necessary to
reinitialise the remote control.
F
Switch on the ignition by pressing the
"START/STOP" button.
F
With a manual gearbox, place the
gear lever in neutral then fully depress
the clutch pedal.
F
With an automatic gearbox, from
mode P, fully depress the brake pedal.
If the fault persists after reinitialisation, contact
a
dealer or a qualified workshop without delay.
F
Press the handle until the point of
resistance to unfold it and access the lock.
F Insert the mechanical key (integral with
the remote control) in the lock to open the
vehicle.
F
Place the electronic key against the back-up
reader on the steering column and hold it
there until the ignition is switched on.
Doors
Retractable handles
The doors are equipped with handles that
unfold and retract automatically depending on
the vehicle state:
-
when unlocking the vehicle, the handles
unfold to allow access to the vehicle,
- when the vehicle is locked, the handles
retract.