DS Automobiles DS 3 CROSSBACK User Manual

07
157
Practical information
Bonnet
The location of the interior bonnet release
lever prevents opening the bonnet when
the left-hand front door is closed.
When the engine is hot, handle the
exterior safety catch and the bonnet
stay with care (risk of burns), using the
protected area.
When the bonnet is open, take care not to
damage the safety catch.
Do not open the bonnet under very windy
conditions.
Stop & Start
Before doing anything under the bonnet,
you must switch off the ignition to avoid
any risk of injury resulting from an
automatic change to START mode.
Cooling of the engine when stopped:
The engine cooling fan may start after
the engine has been switched off.
Take care with objects or clothing that
could be caught in the blades of the
fan!
Opening
F Open the left-hand front door.
F Pull the release lever, located at the bottom
of the door frame, towards you.
F
Lift the safety catch and raise the bonnet.
F
Unclip the stay from its housing and place it
in the support slot to hold the bonnet open.
Closing
F Take the stay out of the support slot.
F
Clip the stay in its housing.
F
Lower the bonnet and release it near the
end of its travel.
F Pull on the bonnet to check that it is locked
correctly.
Because of the presence of electrical
equipment under the bonnet, it is
recommended that exposure to water
(rain, washing, etc.) be limited.
Engine compartment
This engine example is given for illustration
purposes only.
The locations of the following elements may
vary:
-
Air filter.
- Engine oil dipstick.
- Engine oil filler cap.

DS Automobiles DS 3 CROSSBACK Specifications

General

Brand	DS Automobiles
Model	DS 3 CROSSBACK
Category	Automobile
Language	English