Light control
Low / High beam
At Key-On, the high beam and low beam lights are
OFF: only the parking lights are turned on.
Once the engine is started, the low beam is
automatically turned on; it is possible to switch from
low beam to high beam and vice versa by pressing
button (7) in positions (B) and (A). If engine is not
started upon key-on, it is anyway possible to switch
high/low beams on by pushing button (7) positions (B)
and (A) on LH switch.
If within 60 seconds from the "manual" switching on
of the low / high beam the engine is not started, the
lights are disabled again (off).
High/low beam switching-off during vehicle
starting
To preserve the motorcycle battery, if when starting
the engine the high/low beams are ON, the headlight
is automatically switched off and then on again when
the engine is started.
Fig. 124
181
To Next Page
Loading...
