Trip time
The instrument panel calculates and displays the trip
time as hhh:mm followed by TRIP TIME. The
calculation considers the time since TRIP1 was last
reset. When TRIP1 is reset, this value is reset as well.
The time count active phase occurs when the engine
is running and the motorcycle is stopped (the time is
automatically stopped when the motorcycle is not
moving and the engine is OFF and restarts when the
counting active phase starts again).
When the reading exceeds 511:00 (511 hours and 00
minutes), the meter is reset and automatically starts
counting from 0 again.
Note
If you change the unit of measurement for an
item connected to Speed (and distance) or
Consumption, the trip time value will be automatically
reset.
TRACK
299
N
LAP
URBAN
98
6
5
4
3
2
1
7
10
11
km/h
RPM x 1000
DTC 1
ABS 1
TRIP TIME
199:59’
Fig. 34
80
To Next Page
Loading...
