STANDARD setting from the fully closed position
(clockwise):
- rebound: loosen adjuster (1) by 1.5 turns (from
fully closed position);
- spring preload: 15 mm (0.59 in) (from fully
uncompressed).
Warning
To turn the preload adjuster ring nut use a pin
wrench. Pay attention to avoid hand injuries by hitting
motorcycle parts in case the wrench tooth suddenly
slips on the ring nut groove while moving it.
Warning
The shock absorber is filled with gas under
pressure and may cause severe damage if taken apart
by unskilled persons.
216
To Next Page
Loading...
