Riding the motorcycle
Running-in recommendations
Maximum rotation speed
Rotation speed for running-in period and during
standard use (rpm):
1) Up to 600 mi (1000 km);
2) From 1000 km (600 mi) to 2500 km (1500 mi).
Up to 1,000 Km (600 mi)
During the first 1000 km (600 mi), keep an eye on the
rev counter. It should never exceed: 5,500 ÷
(included) 6,000 rpm.
During the first hours of riding, it is advisable to run
the engine at varying load and rpm, though still
within recommended limit.
To this end, roads with plenty of bends and even
slightly hilly areas are ideal for a most
running-in of engine, brakes and suspensions.
For the first 100 km (60 mi) use the brakes gently.
Avoid sudden or prolonged braking. This will allow
the friction material on the brake pads to bed in
against the brake discs.
So that the mechanical of the motorcycle can
adapt to each another, and especially so the life of
the basic engine is not avoid harsh
accelerations and do not run the engine at a high
rpm for an extended time, especially uphill.
the drive chain should be inspected
frequently. Lubricate as required.
During the first 1000 km (600 mi) of the odometer
(vehicle running-in period), or up to the first service,
a engine rpm limiter is set and is indicated
when the needle wake becomes amber yellow.
When the needle wake becomes amber yellow and
blinking, the instrument panel is warning the
rider to up, so as not to exceed a rpm.
If the number of rpm is lower than 1000 rpm, the
needle wake is not displayed.
85
To Next Page
Loading...
Need help?
General
