31
● Type of content and current playback time, e.g. "HDMV 00:25:53".
● Current disc title, e.g. "Title 1/11".
● Current disc chapter, e.g. "Chapter 8/27".
● Current bitrate, e.g. "Bitrate 34.43 Mbps".
AUDIO: First press: display information on current sound track.
● Subsequent presses: switch to the next sound track.
SUBTITLE: First press: display information on current subtitles.
● Subsequent presses: switch to subsequent subtitles.
ANGLE: Choose the viewing angle (if supported by the particular disc).
2nd audio: Turn the secondary audio track on/off, in case such track is present on a particular
disc.
PIP: Toggles showing the picture-in-picture content, if such content is present on a particular
disc.
ZOOM: First press: switch to the picture zooming mode, display information on current zoom
settings.
● Subsequent presses: switch to subsequent zoom setting: 2X, 4X, 8X, 16X, ZOOM OFF.
● Left/Right/Up/Down: Navigation through the frame enlarged in ZOOM mode.
SETUP: Switch to the picture parameters setting mode (contrast, brightness, hue, saturation).
● Subsequent presses: select the next parameter.
● Left/Right: Adjust the selected parameter.
If after pressing an RC button, the INVALID KEY indication is displayed, it means that the
procedure assigned to this button is currently disabled, or not supported for this disc.
DVD-Video Playback
Note: to play optical discs, an appropriate external optical disc drive should be connected to
the player.
When you play a DVD-Video disc, the player uses a so called "DVD playback mode". In the
DVD playback mode, DVD features such as DVD menu and DVD subtitles are supported.
To play a DVD-Video disc, navigate to the Main screen of the file browser, and insert the disc
into a DVD drive. The player will recognize the inserted DVD disc and enable the correspond-
ing optical drive item on the Main screen. Select this optical drive item and press ENTER or
PLAY. The player will start loading the DVD-Video disc.
Depending on a particular DVD-Video disc, its loading may take some time (up to several
minutes). While a DVD-Video disc is being loaded, a blank screen is shown. After the DVD-
Video disc is loaded, the player will start playback of the disc (e.g. will show the disc menu).
Note: when stopping the playback of a DVD-Video disc, the player remembers the current
playback position and automatically restores it when the disc is loaded next time. To start
playback of a DVD-Video disc from the very beginning (just as if it has never been played),
press CLEAR two times after the disc is loaded.
In the DVD playback mode, the following RC buttons are available:
Left/Right/Up/Down/ENTER/RETURN (in DVD menu): Navigate the disc menu.
POP UP MENU: Display an interactive menu of the disc (selection of scenes, switching be-
Playback
To Next Page
Loading...
