1-13
Chapter 1 Before Operation
4-2. Menu list
4-2-1. Setting Menu
The setting menu is displayed if you press the key with the top screen displayed.
Setting
Saddle/Fold
[1]
[2]
[3]
[4]
01
A4
01
Trimming On
Setting
The setting menu items are as follows. When the sheet feeder or the DFC-100 is connected to the DBM-150
as a upstream unit, the setting menu is not displayed. Make settings for the following items on the upstream
unit.
No. Setting item Setting details
[1] Memory No. Select a memory No. that you want to overwrite.
No.1 to 16
[2] Binding mode Select a binding mode.
[Saddle/Fold][Side][CornerF][CornerB][Fold]
*[Side] [CornerF] or [CornerB] is displayed only when the CORNER AND SIDE
STAPLE KIT is used.
[3] Paper size Select a paper size.
[A5] [A4] [A4 ] [A3] [A3SR] [B5] [B5 ] [B4] [LTR] [LTR ] [LGL] [LGR] [STMT]
[Custom]
When stacked with long edge feed, is displayed to the right of the paper size.
*If the current paper size is not appropriate for the binding mode you have
selected, the paper size is automatically changed to other paper size.
*The custom size you can specify varies depending on the binding mode.
Saddle/Fold: 210 to 460 mm/8.27 to 18.11 inches (length), 120 to 320
mm/4.72 to 12.60 inches (width)
Side: 180 to 231 mm/7.09 to 9.09 inches (length), 200 to 320 mm/7.87 to
12.60 inches (width)
Corner: Any specic value cannot be entered. Only [A4 ] and [LTR ] are
available.
[4] [Trimming On]/[Trimming
O]
Select whether to apply trimming.
[Trimming On]/[Trimming O]
*Displayed when you have set a binding mode either to [Saddle/Fold] or to [Fold]
with the DBM-150T attached to the DBM-150 as a downstream unit.
To Next Page
Loading...
Need help?
General
