3-14
Chapter 3 Advanced Operation
4
Loosen the guide xing screw.
Max. stacking amount
: 25 mm/0.98 inch
Paper feed
direction
5
Stack the single-folded paper on the
paper feed tray with the folded line
toward the anti-operating side.
The stacking amount is equivalent to about
half (25 mm/ 0.98 inch) of the height of the
paper feed guide on the folding side.
6
Attach the paper feed guide lightly to
the side of the paper and tighten the
xing screws.
7
Lower the paper set lever. (DF-970)
4-1-2. Adjustment of the parts
Do not touch the power switch
with wet hands.
Otherwise electric hazards may occur.
1
Turn o the power switch.
Otherwise electric hazards
may occur.
Do not touch the power
plug with wet hands.
2
Disconnect the power plug from the
outlet.
3
Take the T-handle hexagonal wrench.
For the location where the T-shape hexagonal wrench is stored, refer to Chapter 1 “2. Setting Up the
Machine”
(p.1-4)
.
To Next Page
Loading...
Need help?
General
